Re: Installer login broken (ncurse?)
On Mar 20, 2005, at 9:01 PM, Matthew Dillon wrote:
>
> :First of all, the installer looks fine.
> :
> :But I can not format the hard drive.
> :newfs /dev/da1s1a times out, and the log reports
> :
> :'write error: 80
> :->>> Exit status: 36'
> :
> :The CD boots from an ide cd-rw unit, and the target
> :disk is a scsi disk, scsi id 1, attached to the mpt1 device.
> :
> :Is using scsi hard drives a known issue?
> :
> :J^2
>
> No, it should work... run the 'dmesg' command (login as root on one
> of the other virtual consoles).
>
I selected the whole disk for dfly, and formatting went fine.
I have even successfully installed working boot loader
(the F1-F5 prompt to select what partition to boot from)
to both disks, and it works fine.
In dmesg, I get seven of:
WARNING: da0 si_iosize_max=0, using DFLTPHYS
for both da0 and da1.
Then five of:
WARNING: #da/0x2000a si_iosize_max=0, using DFLTPHYS
On the first virtual console (I presume it's stderr) there is
plenty of error messages, they look like this:
SE32 0xda9d2ab8: Addr=0x73951000 FlagsLenght=0xd5000700
HOST_TO_IOC LAST_ELEMENT END_OF_BUFFER END_OF_LIST
(I only copied he last one)
Here is a screenshot from an earlier attempt:
http://213.238.234.141/proj/dfly/mpt-error.shtml
I have no idea what's wrong, Solaris works just fine with both disks.
J^2
討論串 (同標題文章)
完整討論串 (本文為第 6 之 29 篇)：