Re: dfly 2.4.1 does not like HP DL360G4p and Smart Array 6400 wi
Sepherosa Ziehau wrote:
> 2009/10/19 Toma=C5=BE Bor=C5=A1tnar <tomaz.borstnar@over.net>:
>> Hello!
>>
>> I have a HP DL360G4p machine with 5 gigs of RAM, internal SATA =
disk
>> and HP SmartArray 6400 controller (2 channels) with 6400EM card (addit=
ional
>> 2 channels attached as daughter card) with MSA20 enclosure with SATA d=
isks -
>> configured as 4 volumes. Install went fine, but dmesg prints some erro=
rs
>> (full dmesg output attached), but here are relevant parts:
>>
>> bge0: <Broadcom BCM5704C Dual Gigabit Ethernet> mem 0xfddf0000-0xfddff=
fff
>> irq 7 at device 2.0 on pci2
>> bge0: CHIP ID 0x21000000; ASIC REV 0x02; CHIP REV 0x21; PCI-X
>> alignment check failed
>> miibus0: <MII bus> on bge0
>> brgphy0: <BCM5704 10/100/1000baseT PHY> on miibus0
>> brgphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
>> 1000baseT-FDX, auto
>> bge0: MAC address: 00:15:60:0f:b0:e8
>> bge1: <Broadcom BCM5704C Dual Gigabit Ethernet> mem 0xfdde0000-0xfddef=
fff
>> irq 7 at device 2.1 on pci2
>> bge1: CHIP ID 0x21000000; ASIC REV 0x02; CHIP REV 0x21; PCI-X
>> alignment check failed
>> alignment check failed
>> miibus1: <MII bus> on bge1
>> brgphy1: <BCM5704 10/100/1000baseT PHY> on miibus1
>> brgphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
>> 1000baseT-FDX, auto
>> bge1: MAC address: 00:15:60:0f:b0:e7
>=20
> I think you mean the "alignment check failed", it is quite common and
> you can jut ignore them
Maybe we should remove the message then? :)
cheers
simon
--=20
<3 the future +++ RENT this banner advert +++ ASCII Ribbon /"\
rock the past +++ space for low CHF NOW!1 +++ Campaign \ /
Party Enjoy Relax | http://dragonflybsd.org Against HTML \
Dude 2c 2 the max ! http://golden-apple.biz Mail + News / \
討論串 (同標題文章)
完整討論串 (本文為第 4 之 5 篇)：