Re: Problem intr11 livelocked
Bill Hacker a 嶰rit :
> Jonathan Buschmann wrote:
>
>> Jonathan Buschmann a 嶰rit :
>>
>>> Hello,
>>>
>>> I've tried to install Dfly on my PC : Asus P4C800-E Deluxe - P4C
>>> 2,6Ghz - Maxtor 120Go connected to RAID Promise - Intel Gb NIC.
>>>
>>> With DragonFly ISO from Stable and current build 27 Feb. But at
>>> boot with or without ACPI i've got : intr11 at XXXXX hz,
>>> livelocked! limiting at 20 000Hz intr11 at XXXX hz, removing
>>> livelock limit
>>>
>>> I was wondering if that's related with the RAID or something
>>> because after the boot and trying to install, the installer doesn't
>>> recognize any hard drive.
>>>
>>> Thanks in advance for your help.
>>>
>>> PS: I've tried to get dmesg or else but without network i don't
>>> know how to do it.
>>
>>
>>
>> So i've tried to get more information and i run this command :
>>
>> vmstat -i | grep 11
>>
>> that gives me : stray irq11 em0 irq11
>>
>> So the problem might be related to em driver what can i do now ?
>
>
> For sure you will be wanting to utilize that on-board Intel CSA 82547EI
> Gigabit Ethernet Controller, but so as to get it running and online, I
> suggest you disable it in the BIOS, and see if that lets you get up and
> running. If so, then insert any 'commodity' NIC (dumb 'ol
> Realtek's are cheap and cheerful) and get online so as to get updates,
> packages, and ports brought current.
>
> The BSD's have reported a problem now and then in supporting some GigE,
> controllers, though I see nothing specific to the one you have.
>
> Presuming you can get it running with another NIC, I recommend cvsup'ing
> to HEAD, (always at least slightly nwer than the ISO CD) doing the full
> 'make' cycle (less /usr/src/Makefile - comments show the options).
>
> - then seeing if you can re-enable the onboard GigE controller.
>
> HTH
>
> Bill Hacker
I tried to disable the onboard GigE controller. But there are still the
same problems.
I've always the messages with "intr 11 .. livelocked!.." and my hard
drive isn't recognized.
Here is the output of 'vmstat -i | grep 11' :
stray irq11
uhci irq11
mux irq11
討論串 (同標題文章)
完整討論串 (本文為第 5 之 15 篇)：