Re: [情報] Micron m4 SSD FW to fix 5184 hours bug

看板Storage_Zone作者 (Eric Chang)時間14年前 (2012/01/16 17:54), 編輯推噓3(306)
留言9則, 3人參與, 最新討論串3/3 (看更多)
※ 引述《Shougon (光)》之銘言: : http://www.crucial.com/support/firmware.aspx : Version: 0309 : Release Date: 01/13/2012 : Change Log: : ‧Changes made in version 0002 (m4 can be updated to revision 0309 directly : from either revision 0001, 0002, or 0009) : ‧Correct a condition where an incorrect response to a SMART counter will : cause the m4 drive to become unresponsive after 5184 hours of Power-on time. : The drive will recover after a power cycle, however, this failure will : repeat once per hour after reaching this point. The condition will allow : the end user to successfully update firmware, and poses no risk to user or : system data stored on the drive. : This firmware update is STRONGLY RECOMMENDED for drives in the field. : Although the failure mode due to the SMART Power On Hours counter poses : no risk to saved user data, the failure mode can become repetitive, and : pose a nuisance to the end user. If the end user has not yet observed : this failure mode, this update is required to prevent it from happening. : If you are using a SAS Expander please do not download this Firmware. : As soon as we have a Firmware Update that will work in these applications : we will release it. : 修復 5184 小時後開始 BSoD 的問題,就算目前沒問題的 user 一樣要 update。 剛剛升級上去 我的環境因為有RAID(M4 64G x4 / RAID 5),所以比較複雜一點。 一開始把機器關機,拔掉RAID卡,紀錄接線的順序(其實本來就有編號,再做一次心安的) 拔掉RAID卡上的sata線 插入燒好映像檔的隨身碟、把四顆SSD接到版子上的SATA1-4 開機進BIOS、調整ahci-->IDE-->reboot-->從隨身碟開機 好,問題來了,我有四顆SSD,但是只有顯示一顆出來... 我是很願意相信原廠應該有考慮到拿來做RAID的情況 理論上不應該出現只有抓到一個的情況?? 但是因為我這台是online的機器 ,停機時間說好只有半小時 所以我也沒有辦法再去測試換線換port等等 直接再把機器shutdown,只單接一顆SSD 這次開機一樣是抓到一顆(廢話) 輸入 yes 後就順利update 然後換第2顆、第3顆、第4顆.... 通通update完成,依照順序接回raid 卡,然後祈禱一下... 開機...順利進入作業系統,以上完畢。 -- 會當凌絕頂,一覽眾山小。 —— 杜甫 -- ※ 發信站: 批踢踢實業坊(ptt.cc) ◆ From: 113.196.143.50

01/16 23:27, , 1F
我手上三顆,他是update完第一顆後才跳第二顆出來
01/16 23:27, 1F

01/16 23:27, , 2F
問要不要update第二顆 第三顆同二
01/16 23:27, 2F

01/16 23:28, , 3F
不過你是raid不知道有沒有差
01/16 23:28, 3F

01/16 23:47, , 4F
原來是這樣啊,我看到只顯示一顆就斷電重接了..
01/16 23:47, 4F

01/17 02:16, , 5F
更新這顆SSD要小心~如有鎂光其他型號它也會詢問是否
01/17 02:16, 5F

01/17 02:17, , 6F
要刷~如果不是M4刷下去就...送廠保固了~(EX: C300)
01/17 02:17, 6F

01/17 02:18, , 7F
刷這顆SSD時~其他HD排線都先拆掉~一顆一顆刷較保險
01/17 02:18, 7F

01/17 10:06, , 8F
樓上說沒錯,後來也有偵測到我的C300 有注意到所以沒
01/17 10:06, 8F

01/17 10:07, , 9F
刷到C300 Y
01/17 10:07, 9F
文章代碼(AID): #1F4_Fa7F (Storage_Zone)
文章代碼(AID): #1F4_Fa7F (Storage_Zone)