bce: Device not configured

Hello,

on an Dell Blade m610 is not possible to change the network media option:

ifconfig bce0 media 100baseTX mediaopt full-duplex up
ifconfig: SIOCSIFMEDIA (media): Device not configured

Setting the media option to "autoselect" and connecting the m610 to a 
100 MBit switch, I always get "no carrier"
only 1g full-duplex seems to be working. I have tested this on 
8.3-prerelease and 9-stable

any Ideas?

cheers
Jan

pciconf -lv
bce0@pci0:1:0:0:        class=0x020000 card=0x02871028 chip=0x163a14e4 
rev=0x20 hdr=0x00
     vendor     = 'Broadcom Corporation'
     device     = 'NetXtreme II BCM5709S Gigabit Ethernet'
     class      = network
     subclass   = ethernet

dmesg
bce0: <Broadcom NetXtreme II BCM5709 1000Base-SX (C0)> mem 
0xda000000-0xdbffffff irq 36 at device 0.0 on pci1
miibus0: <MII bus> on bce0
brgphy0: <BCM5709S 1000/2500baseSX PHY> PHY 2 on miibus0
brgphy0:  1000baseSX-FDX, auto
bce0: Ethernet address: 00:26:b9:fb:04:0c
bce0: ASIC (0x57092000); Rev (C0); Bus (PCIe x4, 2.5Gbps); B/C (5.0.11); 
Bufs (RX:2;TX:2;PG:8); Flags (SPLT|MSI|MFW); MFW (NCSI 2.0.5)
Coal (RX:6,6,18,18; TX:20,20,80,80)
bce1: <Broadcom NetXtreme II BCM5709 1000Base-SX (C0)> mem 
0xdc000000-0xddffffff irq 48 at device 0.1 on pci1
miibus1: <MII bus> on bce1
brgphy1: <BCM5709S 1000/2500baseSX PHY> PHY 2 on miibus1
brgphy1:  1000baseSX-FDX, auto
bce1: Ethernet address: 00:26:b9:fb:04:0e
bce1: ASIC (0x57092000); Rev (C0); Bus (PCIe x4, 2.5Gbps); B/C (5.0.11); 
Bufs (RX:2;TX:2;PG:8); Flags (SPLT|MSI|MFW); MFW (NCSI 2.0.5)
Coal (RX:6,6,18,18; TX:20,20,80,80)

_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscribe@freebsd.org"