Re: Thinkpad T410: resume broken

On 05/21/2014 21:22, Hans Petter Selasky wrote:
> On 05/21/14 21:16, Jan Henrik Sylvester wrote:
>> Unfortunately, my USB mouse does not work anymore: After the first
>> resume, it took a few seconds until it worked again (the build in
>> touchpad was back immediately). After the second resume, it would not
>> work anymore at all, even after reconnecting it to a different EHCI
>> port. It does work at a XHCI, though, until the next resume. Anyhow,
>> this is obviously not related to the original problem.
> 
> Hi,
> 
> USB controller are being reset at resume, so I think this indicates a
> more fundamental PCI/BUS problem.

Looking through dmesg, it seems that other USB devices (build-in) are
reappearing (Qualcomm Gobi 2000, Broadcom Bluetooth Device) after
resume, just not the mouse.

Are these lines likely related?

pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.PEG_:
AE_BAD_PARAMETER
pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.EXP1:
AE_BAD_PARAMETER
pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.EXP2:
AE_BAD_PARAMETER
pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.EXP4:
AE_BAD_PARAMETER
pci0: failed to set ACPI power state D2 on \134_SB_.PCI0.EXP5:
AE_BAD_PARAMETER

Thanks,
Jan Henrik
_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"