Re: dfly hangs about a minute on the boot up when it's trying to
daniel olsson wrote:
> Thank you Bill i will take a look at the page later today and see what i can
> do.
>
Welcome!
Forgot to mention - do this first - it will require four to eight reboots:
1) Interrupt POST, enter BIOS, look for 'PNP/PCI Configuration' (or similar)
set MB BIOS to 'PNP OS Installed: NO' or similar.
- reboot, tel DFLY to boot 'With ACPI Disabled (2)
observe time-out on the SATA, , save dmesg to a
file and add your comments as to the above
settings and results.
- Do the same with DFLY normal boot.
3) Change MB BIOS to 'PNP OS installed: YES'
do two re-boots, as above ACPI-aware and not.
- If the SATA is on the MB, repeat with it enabled/disabled.
- If the SATA is add-on, try interrupting the Sil BIOS
and see if it has more than one mode...
- If comparison of the above is still 'no joy',
see if the MB has a 'boot other devices' setting
that can be optioned off, and if that makes any difference.
Only then - if still 'no joy' will you have to look at
modifying the DragonFly device scan.
(Else live with the delay, or yank the Sil controller.)
;-)
HTH,
Bill
>
> "daniel olsson" <d.ubuntu@gmail.com> wrote in message
> news:4236c2fe$0$718$415eb37d@crater_reader.dragonflybsd.org...
>
>>dfly hangs about a minute on the boot up when it's trying to recognise my
>>SATA controller.But i have disabled my SiL 3112 SATA conroller in bios but
>>it's searching anyway. i got a warning message after the acd0 on the boot
>>up too. i have pasted a bit from my dmesg in here too.
>>
>>
>>
>>
>>
>>atapci1: <SiI 3112 SATA controller> port
>>
>>0xac00-0xac0f,0xa800-0xa803,0xa400-0xa407,0xa000-0xa003,0x9c00-0x9c07
>>
>>mem 0xdc130000-0xdc1301ff irq 11 at device 10.0 on pci1
>>
>>ata2: at 0x9c00 on atapci1
>>
>>ata3: at 0xa400 on atapci1
>>
>>
>>
>>acd0: CD-RW <Memorex 24MAXX 1040> at ata1-master PIO4
>>
>>**WARNING** waiting for the following device to finish configuring:
>>
>>xpt: func=0xc0145c3c arg=0
>>
>>**WARNING** waiting for the following device to finish configuring:
>>
>>xpt: func=0xc0145c3c arg=0
>>
>>**WARNING** waiting for the following device to finish configuring:
>>
>>xpt: func=0xc0145c3c arg=0
>>
>>**WARNING** waiting for the following device to finish configuring:
>>
>>xpt: func=0xc0145c3c arg=0
>>
>>**WARNING** waiting for the following device to finish configuring:
>>
>>xpt: func=0xc0145c3c arg=0
>>
>>Giving up, interrupt routing is probably hosed
>>
>>Mounting root from ufs:/dev/ad0s2a
>>
>>/Daniel
>>
>
>
>
討論串 (同標題文章)
完整討論串 (本文為第 3 之 17 篇)：