Re: problem with vr0
On Sat, Jan 15, 2005 at 12:32:37PM -0800, Matthew Dillon wrote:
>
>:I'm having a problem with an onboard vr0 interface
>:
>:# pciconf -lv
>:vr0@pci0:18:0: class=0x020000 card=0xf6831297 chip=0x30651106 rev=0x78 hdr=0x00
>: vendor = 'VIA Technologies Inc'
>: device = 'VT6102 Rhine II PCI Fast Ethernet Controller'
>: class = network
>: subclass = ethernet
>:
>:# ifconfig vr0
>:vr0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
>: inet6 fe80::230:1bff:feb4:99a8%vr0 prefixlen 64 scopeid 0x3
>: ether 00:30:1b:b4:99:a8
>: media: Ethernet autoselect (none)
>: status: no carrier
>:
>:
>:I can assign an address but it still doesn't sense the media, I did a
>:full buildworld/kernel from stable, yesterday. Don't have dmesg until I
>:install again. <sigh> this new amd64 shuttle was selected for supported
>:hardware... is there anything else I can provide?
>:
>:// George
>:--
>:George Georgalis, systems architect, administrator Linux BSD IXOYE
>
> Do you get a link light when you plug the media in?
Yes.
// George
--
George Georgalis, systems architect, administrator Linux BSD IXOYE
http://galis.org/george/ cell:646-331-2027 mailto:george@galis.org
討論串 (同標題文章)
完整討論串 (本文為第 3 之 18 篇)：