[請益] 關於薄膜拉伸速率的決定(ASTM D882-12)?
小弟需執行一拉伸實驗，是有關於薄的薄膜拉伸，
參考他人測試的規範應該為ASTM D882，
問題是小弟經驗不足研讀過後小弟理解為其決定拉伸速率的規則有其特殊性，
想請問是否有人是否有針對此類的測試有深入探討，可讓我請益，
問題主要是為何此類的測試拉伸速率有特別的決定方式與
如何決定最後產品的拉伸速率?
這些拉伸速率的不同對測試結果與分析有何影響?
相關原文如下:
9. Speed of Testing
9.1 The speed of testing is the rate of separation of the two
members (or grips) of the testing machine when running idle
(under no load). This rate of separation shall be maintained
within 5 % of the no-load value when running under fullcapacity
load.
9.2 The speed of testing shall be calculated from the
required initial strain rate as specified in Table 1. The rate of
grip separation shall be determined for the purpose of these test
methods from the initial strain rate as follows:
The speed of testing shall be calculated from the
required initial strain rate as specified in Table 1. The rate of
grip separation shall be determined for the purpose of these test
methods from the initial strain rate as follows:
A=BC
A = rate of grip separation, mm (or in.)/min,
B = initial distance between grips, mm (or in.), and
C = initial strain rate, mm/mm·min (or in./in.·min).
In cases where conflicting material classification, as
determined by percent elongation at break values, results in a
choice of strain rates, the lower rate shall be used
If modulus values are being determined, separate specimens
shall be used whenever strain rates and specimen
dimensions are not the same as those employed in the test for
other tensile properties
希望有高手可以讓我請益，甚至若嫌打字太麻煩我撥電話請較亦可，謝謝
--
※ 發信站: 批踢踢實業坊(ptt.cc)
◆ From: 140.96.169.89