[問題] modeling 跑不出圖形已回收
做了一個檔案 在RUN的時候出現了錯誤
Warning: Signal storage reuse is turned on. Outport display for subsystem
blocks may be incorrect.
### Starting Real-Time Workshop build procedure for model: M4A45matlab
### Real-Time Workshop build procedure for model: 'M4A45matlab' aborted
due to an error.
Warning: Matching "Goto" for "From" 'M4A45matlab/From' not found.
之後是一連串相似的錯誤
後面還有
Warning: Input port 3 of 'M4A45matlab/Subsystem3' is not connected.
Warning: Input port 2 of 'M4A45matlab/Subsystem7' is not connected.
Warning: Using a default value of 0.2 for maximum step size.
The simulation step size will be equal to or less than this value.
You can disable this diagnostic by setting 'Automatic solver parameter
selection' diagnostic to 'none' in the
Diagnostics page of the configuration parameters dialog.
請問能指點一下該注意什麼地方嗎?謝謝
--
※ 發信站: 批踢踢實業坊(ptt.cc)
◆ From: 125.232.140.146