Re: KERN - mfi driver for Dell raid h200 on r210 servers

On 29 Jan 2011, at 23:24, "Bjoern A. Zeeb" <bzeeb-lists@lists.zabbadoz.net> w=
rote:

> On Sat, 29 Jan 2011, Damien Fleuriot wrote:
>=20
>> Hello lists,
>>=20
>>=20
>> I'm trying to get FreeBSD 8.0 or 8.1 to run on a Dell poweredge r210 serv=
er.
>>=20
>> It ships with a SATA/SAS h200 RAID controller.
>>=20
>>=20
>> Sadly, the MFI driver doesn't seem to register for this card...
>>=20
>>=20
>> Find below the pciconf -lcvb
>>=20
>> --
>> none6@pci0:1:0:0:       class=3D0x010700 card=3D0x1f1d1028 chip=3D0x00721=
000
>> rev=3D0x02 hdr=3D0x00
>>   vendor     =3D 'LSI Logic (Was: Symbios Logic, NCR)'
>>   class      =3D mass storage
>>   subclass   =3D SAS
>>   bar   [10] =3D type I/O Port, range 32, base 0xfc00, size 256, enabled
>>   bar   [14] =3D type Memory, range 64, base 0xdf2b0000, size 65536, enab=
led
>>   bar   [1c] =3D type Memory, range 64, base 0xdf2c0000, size 262144, ena=
bled
>>   cap 01[50] =3D powerspec 3  supports D0 D1 D2 D3  current D0
>>   cap 10[68] =3D PCI-Express 2 endpoint max data 256(4096) link x8(x8)
>>   cap 03[d0] =3D VPD
>>   cap 05[a8] =3D MSI supports 1 message, 64 bit
>>   cap 11[c0] =3D MSI-X supports 15 messages in map 0x14
>> --
>>=20
>>=20
>> I have added the following to /usr/src/sys/dev/mfi/mfi_pci.c at line 119:=

>> --
>> {0x1000, 0x0072, 0x1028, 0x1f1e, MFI_FLAGS_GEN2,  "Dell PERC H200 Integra=
ted"},
>> --
>=20
> It's 1f1d not 1f1e.  I hope it was only a paste problem into email?
>=20

Nope no copy paste problem, I shall try again tomorrow with 1f1d then.
I found this line on the nginx site where the issue was being discussed.

Will post back my results asap.
>=20
>>=20
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscribe@freebsd.org"