kernel: acpi_perf0: Px transition to 3000 failed kernel: acpi_pe

Hello!

I'm attempting my first use of FreeBSD via an install of pfSense 2.1.3, whi=
ch runs on=A0FreeBSD 8.3, AFAIK.

I am getting the following entries over and over in my logs:

Jun 8 18:06:19 kernel: acpi_perf0: Px transition to 3000 failed
Jun 8 18:06:19 kernel: acpi_perf0: set freq failed, err 6

Perhaps some useful info:

$ dmesg | grep -i cpu
CPU: Intel(R) Pentium(R) 4 CPU 3.00GHz (2992.59-MHz K8-class CPU)
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
=A0cpu0 (BSP): APIC ID: =A00
=A0cpu1 (AP/HT): APIC ID: =A01
cpu0: <ACPI CPU> on acpi0
cpu1: <ACPI CPU> on acpi0
acpi_perf0: <ACPI CPU Frequency Control> on cpu0
p4tcc0: <CPU Frequency Thermal Control> on cpu0
est1: <Enhanced SpeedStep Frequency Control> on cpu1
est: CPU supports Enhanced Speedstep, but is not recognized.
est: cpu_vendor GenuineIntel, msr f2700000f27
p4tcc1: <CPU Frequency Thermal Control> on cpu1
SMP: AP CPU #1 Launched!

While using Ubuntu, this same machine had a microcode issue reported in the=
 syslog, but I was able to fix it using a package called intel-microcode. I=
'm not sure if this FreeBSD issue is similarly related, but it would be gre=
at if someone can point in the right direction.

Thanks!

Paul
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "freebsd-questions-unsubscribe@freebsd.org"