Re: Install 10.0-RC3 on MacBookPro Late 2013

Right, but it used to work. That's the confusing bit. How'd you make
it not work? :)

-a

On 6 January 2014 01:52, Hans Petter Selasky <hps@bitfrost.no> wrote:
> On 01/06/14 10:41, Huang Wen Hui wrote:
>>
>> % grep xhci dmesg-xhci-debug.txt | more
>> xhci0: <Intel Lynx Point USB 3.0 controller> mem 0xc1e00000-0xc1e0ffff at
>> device 20.0 on pci0
>> xhci0: attempting to allocate 1 MSI vectors (8 supported)
>> xhci0: using IRQ 266 for MSI
>> xhci0: MSI enabled
>
>
> Those USB timeouts are most likely due to port routing not working properly.
> It is because intel did something special to their lynx point series.
>
> Try to set :
>
> hw.usb.xhci.xhci_port_route = "-1"
>
> in /boot/loader.conf
>
> --HPS
_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"